Restore Your Vehicle’s Performance and Reliability
Is your 2014 Impala or other GM vehicle experiencing frustrating issues like stalling, hesitation on acceleration, or a dreaded no-start condition? These are classic signs of a failing Fuel Pump Control Module (FPCM), also known as a Fuel System Control Module (FSCM). This critical component regulates the voltage sent to your fuel pump, ensuring your engine gets the precise amount of fuel it needs. When it fails, it can leave you stranded and facing a costly trip to the dealership. This is the definitive solution to get you back on the road with confidence.
We offer a genuine GM-spec FPCM (part number 22874300) that arrives at your door fully programmed to your vehicle’s specific VIN. Forget about expensive diagnostic tools or paying for dealer programming. Simply provide your VIN at checkout, and our technicians will flash the module with the latest factory software updates. This ensures perfect communication with your vehicle’s computer system and restores original performance and fuel efficiency. It’s the closest you can get to a plug-and-play repair for a complex electronic part.
A Technician’s Notebook: The Intermittent Stall Case
A customer brought in a 2014 Chevy Cruze with a problem that was driving them crazy: it would run perfectly for days, then suddenly stall at a stoplight. No check engine light, no consistent codes. They had already replaced the fuel pump itself with no luck. In my experience, intermittent electrical issues, especially those related to fuel delivery, often point away from the pump and toward the controller. We hooked up a scope to monitor the voltage going to the fuel pump and saw it drop out randomly. The culprit was a failing 2014 Impala Fuel Pump Module (the same part used in the Cruze). The internal electronics were overheating and cutting out. A new, pre-programmed module fixed the issue in under 30 minutes, saving the customer from more guesswork and wasted money.
Common Signs of a Failing FPCM
- ✔ Engine cranks but will not start.
- ✔ Vehicle starts and then immediately stalls.
- ✔ Severe hesitation or sputtering during acceleration.
- ✔ Noticeable loss of engine power.
- ✔ Reduced fuel economy.
- ✔ Check Engine Light with Diagnostic Trouble Codes (DTCs) like P069E, P0230, P0627, or U0109.
A Straightforward Guide to Installation
Replacing the FPCM is a manageable job for a confident DIYer. While the exact location varies slightly by model, it’s typically found in the trunk or behind a rear quarter panel trim piece.
- Safety First: Disconnect the negative terminal from your vehicle’s battery to prevent any electrical shorts.
- Locate the Module: On most models like the Impala, Cruze, or Sonic, the module is mounted on the right-hand (passenger side) inner quarter panel, often accessible by removing trunk liner panels.
- Disconnect and Remove: Carefully unplug the electrical connector(s) from the old module. Then, remove the nuts or bolts securing it to the vehicle body.
- Install the New Module: Mount your new, pre-programmed module in the same location, securing it with the original hardware.
- Reconnect and Test: Plug the electrical connector(s) firmly into the new module. Reconnect the negative battery terminal. Turn the key to the ‘On’ position for a few seconds to prime the fuel system before starting the engine.
Verified Vehicle Compatibility
This module is a direct replacement for part numbers 22874299 and 22874300. It is guaranteed to fit the following vehicles:
- ✔ 2014 Cadillac XTS: (right rear quarter panel)
- ✔ 2014 Chevrolet Camaro: 3.6L & 6.2L (quarter panel behind right hand door)
- ✔ 2014 Chevrolet Caprice: (Fuel Pump)
- ✔ 2013-2014 Chevrolet Cruze: (RH inner quarter panel), ID 22874300
- ✔ 2014 Chevrolet Impala: VIN 1 (4th digit, new style), (RH rear quarter panel)
- ✔ 2013-2014 Chevrolet Sonic: (RH inner quarter panel)
- ✔ 2013-2014 Chevrolet Trax: (RH inner quarter panel)
- ✔ 2013-2014 Chevrolet Volt: (RH inner quarter panel)
- ✔ 2013-2014 Buick Encore: (RH inner quarter panel)
- ✔ 2013-2014 Buick Verano: (RH inner quarter panel)
- ✔ 2013 Chevrolet Orlando: (RH inner quarter panel)
Frequently Asked Questions
Do I need to do any programming myself?
No. This module is delivered to you fully programmed with the latest GM software. We use the VIN you provide during checkout to ensure it’s a perfect match for your vehicle’s specific configuration. It’s ready for installation right out of the box.
How do I provide my VIN?
After you complete your purchase, you will need to send us your 17-digit Vehicle Identification Number (VIN). We cannot ship the part until we receive your VIN to perform the required programming.
What does the Fuel Pump Control Module do?
The FPCM is a small computer that acts as a smart controller for your fuel pump. It receives commands from the main Engine Control Module (ECM) and precisely adjusts the speed of the fuel pump to deliver the exact amount of fuel the engine needs under all conditions, improving efficiency and performance.
Where is this module located on my 2014 Impala?
On the 2014 Impala (new body style), the FPCM is located in the trunk, behind the trim panel on the right-hand (passenger) side rear quarter panel.
Is this a reliable replacement part?
Absolutely. This is a high-quality replacement part built to meet or exceed original equipment specifications. By programming it with the latest GM software updates, we also ensure any known factory bugs are corrected, providing a dependable, long-term fix.