Is Your 2014 Impala Stalling, Hesitating, or Refusing to Start?
There’s nothing more frustrating than a car that won’t run reliably. If your Chevrolet Impala is experiencing sudden stalls, sputtering during acceleration, or has become a no-start headache, a faulty Fuel Pump Control Module (FPCM) is a very common culprit. This small but critical component is responsible for regulating the voltage sent to your in-tank fuel pump. When it fails, it starves your engine of the precise fuel pressure it needs, leading to a host of drivability nightmares and often triggering diagnostic trouble codes related to fuel pressure or communication errors.
In my 20+ years as a diagnostic technician, I’ve seen this exact failure countless times on this GM platform. Just last month, a 2014 Impala was towed to my shop with a no-start condition. The owner had already replaced the fuel pump, but the problem persisted. A quick scan showed a U-code for lost communication with the FPCM. The module itself, located in the right rear quarter panel, had failed internallyโa scenario I’ve diagnosed on dozens of Impalas, Cruzes, and Camaros.
The Dealership-Free Solution You Need
This isn’t just a replacement part; it’s a complete, ready-to-install solution. We take a genuine GM module and program it with the very latest official software updates specifically for your vehicle’s VIN. This means you can bypass the expensive dealership visit for programming and diagnostics. Get your vehicle running right again, right in your own driveway.
- โ Fixes Common Issues: Eliminates stalling, hesitation, rough idle, and no-start conditions caused by a faulty FPCM.
- โ VIN-Programmed & Ready to Install: We flash the module to your specific vehicle using your VIN. No extra steps needed.
- โ No Dealer Visit Required: This is a true plug-and-play part, saving you hundreds in labor and programming fees.
- โ Updated GM Software: Programmed with the newest calibrations from General Motors to ensure optimal performance and longevity.
- โ Direct-Fit Replacement: Guaranteed compatibility with part numbers 22874299 and 22874300.
Easy Installation for Your 2014 Impala Fuel Pump Module
Replacing the FPCM is a straightforward job that most DIY mechanics can handle in under an hour with basic tools. The module is typically located behind the trunk liner on the passenger side.
Expert Pro Tip from a 20-Year Tech
Before you plug in your new module, take a moment to inspect the vehicle’s wiring harness connector. The location in the quarter panel can sometimes be exposed to moisture. Look for any signs of green or white corrosion on the pins. If you see any, clean them thoroughly with a small brush and electrical contact cleaner. A poor connection is a leading cause of repeat module failure, and this simple check can save you from future headaches.
- Safety First: Disconnect the negative terminal from your vehicle’s battery.
- Access the Module: In your 2014 Impala, open the trunk and remove the clips holding the right-side (passenger side) liner in place. Gently pull it back to expose the FPCM.
- Disconnect and Remove: Carefully unplug the electrical connector(s) from the old module. Then, remove the nuts or bolts securing it to the vehicle body.
- Install the New Module: Mount your new, pre-programmed module in the same location and secure it with the original hardware.
- Reconnect: Plug the wiring harness connector firmly into the new module. You should hear a click.
- Final Steps: Re-install the trunk liner and reconnect the negative battery terminal. The vehicle is now ready to start.
Guaranteed Fitment For a Wide Range of GM Vehicles
While this is a perfect solution for the 2014 Impala Fuel Pump Module, it also fits a variety of other GM models. Please verify your vehicle is on this list:
- Buick Encore: 2013-2014
- Buick Verano: 2013-2014
- Cadillac XTS: 2013-2014
- Chevrolet Camaro: 2014 (3.6L & 6.2L)
- Chevrolet Caprice: 2014
- Chevrolet Cruze: 2013-2014 (ID 22874300)
- Chevrolet Impala: 2014 (New Style, VIN 1)
- Chevrolet Orlando: 2013
- Chevrolet Sonic: 2013-2014
- Chevrolet Trax: 2013-2014
- Chevrolet Volt: 2013-2014
Don’t let a small electronic module keep your car off the road. Order today, provide your VIN at checkout, and we’ll ship a fully programmed, ready-to-install FPCM directly to you.