Is Your Camaro Stalling, Hesitating, or Refusing to Start?
If you’re experiencing erratic engine behavior like sudden stalls, rough idling, a crank-no-start condition, or a check engine light with codes like P069E or U0109, the culprit is often a failing Fuel Pump Control Module (FPCM), also known as a Fuel System Control Module (FSCM). In my 20+ years as a diagnostic technician, I’ve seen this exact issue hundreds of times on modern GM vehicles. The FPCM is the electronic brain that tells your fuel pump how much pressure to deliver. When it fails, your engine is starved of fuel, leading to frustrating and unpredictable drivability problems.
A Technician’s Real-World Experience
“A customer’s 2014 Camaro SS came into my shop last week. It would start fine when cold but would stall at red lights after driving for 20 minutes. He had already replaced the in-tank fuel pump, but the problem persisted. A quick data scan showed the commanded fuel pressure was correct, but the actual pressure was dropping off intermittently. The issue wasn’t the pump; it was a heat-soaked FPCM failing under load. We replaced it with one of our pre-programmed modules, and the car has run perfectly ever since. Don’t guess and waste money on the wrong partsโthis is the solution.”
The Direct Solution: A VIN-Programmed 2014 Camaro Fuel Pump Module
This isn’t just a replacement part; it’s a complete, ready-to-install solution. We take a genuine GM-spec module and professionally program it with the latest, most stable software release from General Motors, specifically matched to your vehicle’s VIN. This critical step ensures your vehicle operates exactly as the manufacturer intended, resolving software glitches and improving fuel delivery logic that older calibrations may have. This module is a direct replacement for part numbers 22874299 and 22874300.
- โ VIN-Programmed for You: Arrives flashed and ready for installation. No dealer programming fees or appointments needed.
- โ Fix Common Fuel Issues: Eliminates stalling, hesitation, long crank times, and related diagnostic trouble codes (DTCs).
- โ Restore Performance: Ensures your engine receives the precise fuel pressure it needs for optimal power and efficiency.
- โ Direct-Fit Guarantee: Engineered to original specifications for a perfect fit and seamless electrical connection.
- โ Broad GM Compatibility: Fits a wide range of vehicles beyond the Camaro (see full list below).
Plug-and-Play Installation: No Dealer Visit Required
You can perform this repair right in your own driveway with basic hand tools. The module is typically located in the trunk area, behind the right-hand side trim panel.
- Safety First: Disconnect the negative terminal from your vehicle’s battery.
- Access the Module: Remove the necessary trunk liners and trim panels on the passenger side to expose the FPCM.
- Disconnect and Remove: Carefully unplug the electrical connectors. Use a small screwdriver to gently release the locking tabs if needed. Then, unbolt the old module from its mounting bracket.
- Install the New Module: Bolt your new, pre-programmed module into place. Securely plug in the electrical connectors until they click.
- Reassemble and Test: Reinstall the trim panels and reconnect the negative battery terminal. Start the vehicle to confirm the repair is complete.
Expert Pro Tip: Check Your Connections
Before plugging in your new module, take 30 seconds to inspect the vehicle’s harness connectors. Look for any signs of water intrusion, corrosion (a white or greenish powder), or pins that have backed out of the connector body. A poor connection is a leading cause of repeat module failure. If you see any corrosion, clean the terminals carefully with an electronics-safe contact cleaner and a small brush.
Wide-Ranging Vehicle Compatibility
This Fuel Pump Control Module is a direct fit for the following vehicles and options:
- CAMARO 2014: Fuel Pump; (quarter panel behind right hand door), 3.6L (VIN 3, 8th digit, opt LFX)
- CAMARO 2014: Fuel Pump; (quarter panel behind right hand door), 6.2L, VIN J (8th digit, opt L99)
- CAPRICE 2014: Fuel Pump
- CRUZE 2013-2014: Fuel Pump; (RH inner quarter panel), ID 22874300
- ENCORE 2013-2014: Fuel Pump; (RH inner quarter panel)
- IMPALA 2014: Fuel Pump; VIN 1 (4th digit, new style), (RH rear quarter panel)
- ORLANDO 2013: Fuel Pump; (RH inner quarter panel)
- SONIC 2013-2014: Fuel Pump; (RH inner quarter panel)
- TRAX 2013-2014: Fuel Pump; (RH inner quarter panel)
- VERANO 2013-2014: Fuel Pump; (RH inner quarter panel)
- VOLT 2013-2014: Fuel Pump; (RH inner quarter panel)
- XTS 2013-2014: Fuel Pump; (right rear quarter panel)
After purchase, please provide your VIN to ensure we can program the module for your specific vehicle before shipping. Get your car back on the road with confidence!