Is Your Saturn VUE Stalling or Not Starting?
There’s nothing more frustrating than turning the key and hearing your engine crank endlessly without starting, or worse, having it stall on you in traffic. If your 2010 Saturn VUE is experiencing these issues, or if you have a check engine light with codes like P069E, U0109, or P0230, the problem is very likely a failed Fuel System Control Module (FSCM).
As a technician with over 20 years of experience, I’ve seen this exact scenario play out hundreds of times on GM vehicles. A customer’s 2010 VUE came into my shop last week with these exact symptoms. They were convinced they needed a new, expensive fuel pump. However, a quick diagnostic scan pointed directly to the FSCM. On the VUE, this module is tucked into the rear engine compartment, where years of heat and vibration take their toll. On trucks like the Silverado or Sierra, it’s on the frame rail, exposed to water, salt, and corrosion. The result is the same: a no-start condition that leaves you stranded.
The Simple, Dealer-Free Solution
This is a direct-fit replacement Fuel System Control Module that solves these common issues. The best part? We handle the most difficult part of the job for you. Every module we ship is pre-programmed to your vehicle’s specific VIN with the latest GM software updates. This means you can skip the expensive trip to the dealership for programming.
- ✔ Plug-and-Play Installation: No programming or special tools required.
- ✔ Save Hundreds: Avoid costly dealer labor and programming fees.
- ✔ Permanent Fix: Solves common symptoms like no-start, stalling, and fuel system error codes.
- ✔ Guaranteed Compatibility: Flashed specifically for your vehicle, ensuring perfect function.
Expert Pro Tip: Check Your Connections
Before installing your new 2010 VUE Fuel Control Module, take 30 seconds to inspect the vehicle’s wiring harness connector. Over time, dirt and moisture can cause corrosion on the pins. Use a small nylon brush and some quality electrical contact cleaner to ensure the connection is pristine. A clean, tight connection is critical for the module to receive accurate signals and power.
Easy DIY Installation Guide
You can get your vehicle back on the road in under an hour with basic hand tools. Here’s how:
- Safety First: Disconnect the negative terminal from your vehicle’s battery.
- Locate the FSCM: On the 2010 Saturn VUE, you’ll find the module in the right-hand (passenger side) rear of the engine compartment. For many GM trucks and SUVs, it’s mounted on the driver’s side frame rail, often near the spare tire.
- Remove the Old Module: Unplug the electrical connector(s). Then, unbolt the old module from its mounting bracket.
- Install the New Module: Bolt your new, pre-programmed FSCM into place using the original hardware.
- Connect and Finalize: Securely plug the wiring harness into the new module until it clicks. Reconnect your battery terminal. The installation is complete!
This module is a direct replacement for part numbers 20850927, 20791901, 20827745, and 20877116. After you place your order, simply provide us with your 17-digit VIN, and we’ll handle the rest. Restore your vehicle’s reliability and performance today.