Restore Your Camaro’s Functionality and Peace of Mind
As a technician with over two decades of experience, I know how frustrating modern vehicle electronics can be. Is your 2014-2015 Camaro suffering from bizarre electrical issues? Flickering lights, power windows with a mind of their own, or security system faults that leave you stranded? You’re likely dealing with a failing Body Control Module (BCM). This isn’t just an annoyance; it’s the central command for your car’s comfort and security features. Driving with a faulty BCM can be unpredictable and unsafe.
Forget the expensive dealership visit and the days of vehicle downtime. We offer a straightforward, reliable solution: a replacement 2014-2015 Camaro Body Control Module that arrives at your door fully programmed and ready for installation. Our professional cloning service transfers all the critical data from your original BCM to this replacement unit. This means your vehicle’s specific key codes, security information, and option settings are perfectly preserved, ensuring a seamless, plug-and-play installation.
A Technician’s Notebook: The Intermittent Gremlin
A customer brought in a ’15 Camaro Convertible with a maddening issue: the interior lights would randomly flicker, and the radio would sometimes shut off on right turns. No check engine light, no consistent codes—just pure frustration. After checking grounds and wiring harnesses, we focused on the BCM. On these GM platforms, I’ve seen internal solder joints on the BCM’s circuit board crack from heat cycles and vibration, causing these exact intermittent connection problems. By swapping in a cloned BCM, we restored stable power to all body circuits, solving the problem without a costly diagnostic goose chase. It’s a classic failure mode for this part.
Common Signs of a Failing BCM
- ✔ Erratic or non-functional power windows, door locks, or interior/exterior lights.
- ✔ The security system or anti-theft light is illuminated, preventing the car from starting.
- ✔ Horn, wipers, or radio operate intermittently or not at all.
- ✔ False warning messages appearing on the driver information center (DIC).
- ✔ Diagnostic trouble codes (DTCs) related to communication loss with other modules, such as U0140, U0155, or U0100.
A Straightforward Guide to Installation
Our cloning service makes this repair accessible for both DIY enthusiasts and professional shops. Here is a general guide for replacing your 2014-2015 Camaro Body Control Module:
- Safety First: Always disconnect the negative terminal from your vehicle’s battery before working on any electronic components.
- Locate the BCM: On the 2014-2015 Camaro, the BCM is typically located behind the right-hand (passenger) side of the dashboard. Access may require removing the glove box or lower dash trim panels.
- Disconnect and Remove: Carefully unplug the electrical connectors from the old BCM. Note their orientation. Then, unbolt or unclip the module from its mounting bracket and remove it from the vehicle.
- Install the Replacement: Mount your new, pre-programmed BCM in the same location. Reconnect all electrical connectors securely, making sure they click into place.
- Reconnect Power: Re-attach the negative battery terminal.
- Test Functionality: Start the vehicle and test all body functions—lights, locks, windows, radio, etc.—to confirm the repair was successful.
Important Post-Installation Note: In some cases, additional steps may be required. If your airbag light is on, a professional scan tool is needed to perform the ‘Setup SDM Primary Key in BCM’ procedure. A ‘Brake Pedal Position Relearn’ may also be necessary for proper brake light and traction control operation. Always consult a factory service manual for vehicle-specific details.
Verified Vehicle Compatibility
This BCM is a direct-fit replacement for units with part number 13590173 and is also compatible with the following part numbers: 13580698, 13578458, 13589115, 13589637, 13590851, 13591300, 13592376, 13593775, 13593776, and 13594564. It fits a range of GM models:
- 2014-2015 Chevrolet Camaro (Body Control, RH dash)
- 2014-2015 Chevrolet Malibu (Body Control, LH kick panel)
- 2016 Chevrolet Malibu (VIN 1, Limited, LH kick panel)
- 2014-2015 Chevrolet Volt (Body Control, RH engine compartment)
- 2014-2016 Chevrolet Spark EV (Body Control, left lower a-pillar)
- 2014-2017 Buick Regal (Body Control, LH dash)
- 2014-2016 Buick LaCrosse (Body Control, LH kick panel)
- 2014-2016 Cadillac SRX (Body Control, LH dash)
- 2014-2016 Cadillac ELR (Body Control, RH cowl / Communication, RH engine compartment)
Frequently Asked Questions
Frequently Asked Questions
How does the cloning service work?
After you place your order, we will contact you with instructions to ship your original BCM to us. Once we receive it, we extract the data and program it into the replacement module. We then ship the ready-to-install part back to you.
Do I need to take my car to the dealer after installation?
No. Because we clone your original module’s data, this is a plug-and-play solution that does not require any additional programming from a dealership, saving you time and money.
Is this the correct part for my vehicle?
Please match your original part number to 13590173 or any of the alternate part numbers listed in our compatibility section. Verifying the part number is the best way to ensure a perfect match.
What if my original BCM is completely dead or missing?
Our cloning service requires a readable original module. If your BCM is physically destroyed, water-damaged, or cannot be read, please contact us before ordering to discuss potential options.
Do I need to send my keys?
No, you only need to send us your original Body Control Module. All necessary key and security information is stored within the module itself.
Is there a core charge?
No, there is no core charge for this item. You can keep your original module after the service is complete.