Programmed 2007-2009 SRX BCM | Body Control Module 15093910 | VIN Matched

Are you tired of dealing with the bizarre and frustrating electrical gremlins in your Cadillac SRX? One minute the power windows work, the next they don’t. The security light flashes for no reason, or worse, your vehicle won’t start at all. These are classic signs that the Body Control Module (BCM)—the central command center for your vehicle’s electronics—is failing. This isn’t just an annoyance; it can be a serious reliability issue. Stop chasing symptoms and replace the core component with a dependable, pre-programmed solution.

This isn’t just a replacement part; it’s a complete service. We take the guesswork and dealership hassle out of the equation. Simply provide us with your vehicle’s VIN after purchase, and our experts will program this BCM with the latest GM software specific to your 2007-2009 SRX. It arrives at your door ready for installation, saving you hundreds in dealership programming fees and diagnostic time.

Common Signs Your BCM is Failing

• ✔️ Erratic or non-functional power windows, door locks, or interior/exterior lights.
• ✔️ The security or anti-theft system light stays on, preventing the engine from starting.
• ✔️ Unexplained battery drain (parasitic draw) that leaves you with a dead battery overnight.
• ✔️ Horn honking randomly or not working when pressed.
• ✔️ Dashboard warning lights flickering or illuminating incorrectly.
• ✔️ Communication error codes stored, such as U0140 (Lost Communication With Body Control Module).

Your Straightforward BCM Installation Guide

Installing your new 2007-2009 SRX BCM is a manageable job for a confident DIYer. For the SRX, the BCM is typically located on the left-hand (driver’s) side of the dash.

1. Safety First: Always disconnect the negative terminal from your vehicle’s battery and wait 10-15 minutes to allow all systems to power down completely.
2. Locate the Module: On the SRX, you’ll usually find the BCM behind the lower dash panel on the driver’s side. You may need to remove a trim panel for access.
3. Disconnect and Remove: Carefully unplug the electrical connectors. They have locking tabs, so be gentle. Once disconnected, unbolt or unclip the old BCM from its mounting bracket.
4. Install the New BCM: Mount the new module in the same position as the old one. Reconnect all electrical connectors firmly until they click into place.
5. Power Up: Reconnect the negative battery terminal. Turn the key to the ‘ON’ position (without starting the engine) and check for proper function of lights and accessories.
6. Post-Installation Checks: Start the vehicle. Note that a Brake Pedal Position Relearn or an Airbag System Sync may be required if related warning lights appear. This is normal and can often be completed with a capable bidirectional scan tool.

Verified Vehicle Compatibility

This module is a direct replacement for a wide range of GM vehicles and interchanges with numerous part numbers. It is crucial to match your part number or provide your VIN for correct programming. This part is confirmed to fit:

This module replaces part numbers: 10382479, 15093910, 15276271, 15299986, 15819552, 15828601, 15837419, 15872388, 15872421, 15880684, 15921352, 15921353, and many more.