Programmed 2005 Rainier Transmission Module YKTB | VIN Matched

End Frustrating Transmission Problems.

Get your vehicle shifting smoothly again with this VIN-programmed Transmission Control Module. It arrives ready to install with the latest GM software, eliminating the need for a dealership visit. This is the direct-fit, reliable solution for fixing harsh shifts, limp mode, and transmission error codes. Order now to restore your vehicle’s performance!

$89.95

+11.99 USPS Priority Shipping

Availability: Only 2 left in stock



SKU: 591-06961-151 Categories: ,
Guaranteed Safe Checkout

Restore Your Vehicle’s Shifting Performance

Are you dealing with the frustrating and often unpredictable issues of a failing transmission control module (TCM)? If your 2005 Buick Rainier or other compatible GM vehicle is experiencing harsh shifting, getting stuck in gear, or throwing transmission-related error codes, you’ve found the reliable, straightforward solution. This isn’t just a replacement part; it’s a complete fix, pre-programmed with the latest GM software specifically for your vehicle’s VIN. This eliminates the need for an expensive trip to the dealership for programming, saving you time and money.

From the Diagnostic Bay: A Common GM Story

Just last month, a 2005 Envoy with the 8-cylinder engine—a vehicle that shares its platform with the Rainier—was towed into my shop. The owner was fed up. The truck would shift hard from 1st to 2nd when cold, and occasionally the check engine light would pop on with a P0758 (Shift Solenoid B Electrical) code. After a few miles, it would go into ‘limp mode,’ stuck in 3rd gear. We checked the wiring and solenoids, which were fine. The culprit? The internal logic of the original TCM was failing intermittently. We installed one of these VIN-programmed modules, performed the simple relearn procedure, and the truck was shifting like new. This is a repair I’ve done hundreds of times; it’s a known issue with a solid fix.

Is Your Vehicle Showing These Symptoms?

A failing TCM can manifest in several ways. If you’re noticing any of the following, it’s a strong indicator that your module needs attention. I’ve seen these issues across countless GM vehicles from this era.

  • ✔ Harsh, erratic, or delayed gear shifts.
  • ✔ The vehicle gets stuck in one gear (often called ‘limp mode’).
  • ✔ Check Engine Light is illuminated with transmission codes like P0700, U0100, P0753, or P0758.
  • ✔ Poor fuel economy due to inefficient shifting.
  • ✔ A complete loss of communication with the transmission, preventing the vehicle from starting.
  • ✔ Inaccurate gear display on the dashboard instrument cluster.

Why a VIN-Programmed Module is the Smart Choice

Choosing a pre-programmed 2005 Rainier Transmission Module is the most efficient path back to a reliable vehicle. The TCM is the ‘brain’ of your automatic transmission, controlling solenoids and sensors to ensure smooth operation. When you order from us, we flash the module with the most current software from General Motors, tailored specifically to your vehicle using the VIN you provide. This ensures perfect communication between the engine, transmission, and other onboard computers, restoring the original factory performance and shift quality.

A Straightforward Guide to Installation

For many of the vehicles on the fitment list, the TCM is located in an accessible spot like the engine compartment or under the air cleaner box. This makes for a manageable DIY job for those with basic tools.

  1. Safety First: Disconnect the negative terminal from your vehicle’s battery.
  2. Locate the TCM: On the 2005 Rainier, it’s typically found in the engine compartment. For other models, it might be under the air cleaner housing or behind a strut tower.
  3. Disconnect Connectors: Carefully unclip the electrical wiring harnesses from the old module. These clips can be brittle, so be gentle.
  4. Remove the Old Module: Unbolt the old TCM from its mounting bracket.
  5. Install the New Module: Bolt your new, pre-programmed module into place.
  6. Reconnect Everything: Securely plug the wiring harnesses into the new TCM until they click. Reconnect the negative battery terminal.
  7. Final Step: While not always required, performing a transmission adaptive pressure relearn with a capable scan tool is recommended for the best immediate performance. However, the vehicle will also relearn on its own over a few drive cycles.

Verified Vehicle Compatibility

This module is a direct replacement for a wide range of GM vehicles and is guaranteed to fit if your vehicle is listed below. Please match your original part number from the list to ensure compatibility: 24223112, 24226863, 24233595, 24234189, 24239427, YBWW, YDFC, YDFD, YDLT, YJHY, YKTB, YKTF.

  • 2005 Buick Allure: (3.6L), (lower air cleaner housing)
  • 2005 Buick LaCrosse: (3.6L), (lower air cleaner housing)
  • 2005 Buick Rainier: Transmission
  • 2004-2005 Buick Rendezvous: (3.6L), (air cleaner box)
  • 2005 Chevrolet Cobalt: (LH strut tower)
  • 2005 Chevrolet Corvette: (LH frame rail)
  • 2005 Chevrolet Trailblazer EXT: (LH engine compartment), (8 cylinder)
  • 2005 GMC Envoy / Envoy XL / Envoy XUV: (LH engine compartment), (8 cylinder)
  • 2005 Pontiac GTO: Transmission
  • 2005 Pontiac Grand Prix: (lower air cleaner housing)
  • 2005 Pontiac Pursuit: (LH strut tower)
  • 2005 Saturn ION: (behind LH strut tower)
Do I need to get this programmed by a dealer?
No. We program the module to your vehicle’s specific VIN before we ship it to you. It arrives ready for installation, saving you the time, cost, and hassle of a dealership visit.

How do I provide my VIN?
After you complete your purchase, you will need to send us your 17-digit Vehicle Identification Number (VIN). You can typically find this on your driver’s side dashboard (visible through the windshield) or on the driver’s side door jamb sticker.

Is this a brand new part?
This is a high-quality, tested, and verified replacement part that has been professionally prepared and programmed with the latest software to ensure reliability and performance that meets or exceeds original specifications.

Will this fix a P0700 trouble code?
A P0700 code is a general code indicating that the TCM has detected a fault and has requested the Check Engine Light to be turned on. While a faulty TCM can cause a P0700, this module will fix the issue if the TCM itself is the source of the problem. You should always scan for other ‘P’ codes to get more specific diagnostic information.

What if I install it and still have issues?
While this module resolves the vast majority of common transmission electronic faults, shifting problems can also be caused by mechanical issues like bad solenoids or internal transmission wear. We recommend a proper diagnosis to confirm the TCM is the fault before purchase. Our experienced support team is here to help if you have questions.

Genuine OEM

Yes

Interchange part number

Condition

Seller refurbished

Model

Rainier

Make

Year

2005

Brand

GM

MPN

yktb

Manufacturer Part Number

Scroll to Top