Programmed 2004-2006 SRX ECM Engine Computer 12592124 / 12581144

Restore Your SRX’s Performance

Fix check engine lights, stalling, and no-start issues with this reliable, used ECM for your 2004-2006 Cadillac SRX. It comes pre-programmed to your vehicle’s VIN with the latest GM software for a simple, plug-and-play installation. No dealer visit required! Get back on the road fastโ€”order today!

$324.95

+11.99 USPS Priority Shipping

Availability: In stock



SKU: 590-07145-8 Categories: ,
Guaranteed Safe Checkout

Is Your Cadillac SRX Running Rough? Get a Reliable, Programmed Solution.

If you’re dealing with a frustrating check engine light, unpredictable stalling, or a vehicle that simply won’t start, a failing Engine Control Module (ECM) is often the culprit. I’ve seen it countless times in my 20+ years in the shop: a perfectly good engine held hostage by a faulty computer. This isn’t just an inconvenience; it’s a critical failure that compromises your vehicle’s performance and safety. We offer a dependable, cost-effective solution with this fully programmed, used GM ECM, part number 12592124.

The Smart Fix: Pre-Programmed for Your Exact Vehicle

Forget the hassle and expense of a dealership visit. The biggest hurdle with replacing an ECM is the programming. We handle that for you. When you purchase this module, you provide us with your Vehicle Identification Number (VIN), and we flash the unit with the latest, most stable software updates directly from GM. This ensures it’s a true plug-and-play part for your vehicle.

  • โœ” VIN-Programmed for You: We load your car’s specific software before we ship. No extra tools or trips to the mechanic are needed for programming.
  • โœ” Latest GM Updates: Your ECM arrives with the newest software, addressing many of the original factory bugs and improving performance.
  • โœ” Cost-Effective Repair: Get a reliable, tested OEM part without the high cost of a brand-new unit from the dealer.
  • โœ” Guaranteed Compatibility: This module, 12592124, is a direct replacement for several service numbers, including 12581144, 12588472, and 19260507.

From the Shop Floor: A Real-World Diagnosis

“A customer’s 2005 SRX came in last week with a baffling issue: it would randomly lose power and stall at stoplights, but only when the engine was hot. No consistent codes were stored, just a generic U-code for lost communication. The owner had already replaced the fuel pump on another shop’s advice, with no success. After running a full diagnostic, we noticed the 5-volt reference signal from the ECM was dropping intermittently. That tiny voltage drop was enough to shut down critical sensors and cause the stall. We swapped in a programmed ECM, and the problem was solved instantly. Itโ€™s a classic case where the symptoms don’t point directly at the computer, but experience tells you where to look.”

Easy Installation for Your 2004-2006 SRX ECM

You can install this module yourself with basic hand tools. Located in the right-hand (passenger side) front of the engine compartment, it’s a straightforward swap. Follow these steps for a successful installation:

  1. Safety First: Always disconnect the negative terminal from your vehicle’s battery and wait 10-15 minutes for the system capacitors to discharge.
  2. Locate the ECM: On your 2004-2006 SRX 3.6L, find the module in the front passenger side of the engine bay.
  3. Disconnect Connectors: Carefully unclip the wiring harness connectors from the old ECM. Inspect the pins on the harness side for any corrosion or damage. Clean them with electrical contact cleaner if necessary.
  4. Remove Old Module: Unbolt the old ECM from its mounting bracket and remove it from the vehicle.
  5. Install New Module: Bolt the new, programmed ECM into place.
  6. Reconnect Everything: Securely plug the wiring harnesses into the new module. You should hear a ‘click’ as they lock. Reconnect your battery terminal.
  7. Final Step: Your vehicle may require a security relearn procedure, which can typically be done by cycling the key. The vehicle is now ready to start.

Common Symptoms of a Failing GM 3.6L ECM:

  • โœ” Persistent Check Engine Light (CEL)
  • โœ” Engine stalling or misfiring
  • โœ” No-start or hard-start condition
  • โœ” Poor fuel economy
  • โœ” Erratic transmission shifting
  • โœ” Communication error codes (U-codes)
  • โœ” Loss of power or sluggish acceleration

Full Compatibility List

While this is the primary part for the SRX, it also fits other GM vehicles. Please verify your part number or consult your mechanic.

  • Cadillac CTS: 2004-2006 (Base, ID 12592124 or 19260507), 2007 (Base)
  • Cadillac SRX: 2004-2006 (3.6L)
  • Buick Allure: 2005-2008 (3.6L)
  • Buick LaCrosse: 2005-2008 (3.6L)
  • Buick Rendezvous: 2004-2005 (ID 19260507), 2006 (3.6L)

Don’t let a faulty computer keep your Cadillac off the road. Order your VIN-programmed ECM today and restore your vehicle’s proper function and reliability.

Condition

Refurbished

Genuine OEM

Yes

MPN

12581144

Interchange part number

PartNumber

590

Model

SRX

Year

2004

Brand

GM

Manufacturer Part Number

, , ,

Hardware Type

Scroll to Top