Restore Your Van’s Brain and Get Back on the Road
If you’re dealing with frustrating engine problems in your 1998 GMC Safari, a failing Powertrain Control Module (PCM) is often the culprit. As a mechanic with over two decades of experience, I’ve seen firsthand how a faulty PCM can cause a cascade of issues, from a simple check engine light to a van that won’t start at all. This isn’t just an inconvenience; it’s a reliability issue that can leave you stranded. This replacement PCM is your direct, cost-effective solution to restore your vehicle’s performance and dependability.
This isn’t just any used part pulled from a yard. We take a quality, tested OEM unit and flash it with the latest official GM software updates specifically for your vehicle. By providing your Vehicle Identification Number (VIN) at checkout, you ensure that the module arrives at your door perfectly matched to your van’s specific configuration. This critical step eliminates the need for expensive dealership programming, saving you time and money and making the repair process significantly smoother for both DIY enthusiasts and professional technicians.
Case Study: A Tricky Diagnosis
I remember a 1998 Chevy Astro van (which shares this exact PCM with the Safari) that came into my shop with a bizarre issue. It would run perfectly for 10-15 minutes, then suddenly stall and refuse to restart for an hour. There were no consistent trouble codes, just a random U-code for lost communication every so often. We checked fuel pressure, spark, and sensors—all were fine. The issue was heat-related internal failure in the PCM. Once the module got warm, a circuit would open. Replacing the PCM with a properly programmed unit like this one solved the problem instantly. It’s a classic example of how a failing 1998 GMC Safari PCM can create phantom issues that are a nightmare to diagnose.
Is Your GMC Safari Showing These Symptoms?
A failing engine computer can manifest in numerous ways. If you’re experiencing any of the following, a faulty PCM could be the root cause:
- ✔ Check Engine Light is on with codes for internal module failure (e.g., P0601, P0605) or communication errors.
- ✔ The engine cranks but refuses to start.
- ✔ Unexplained stalling or rough idling, especially after the engine warms up.
- ✔ Poor fuel economy and a noticeable loss of power.
- ✔ Harsh or erratic automatic transmission shifting.
- ✔ Inconsistent or non-functioning gauges on the instrument cluster.
- ✔ Failure to pass an emissions test due to module-related faults.
A Straightforward Guide to Installation
Installing your replacement 1998 GMC Safari PCM is a manageable job for a confident DIYer. Taking your time and following a logical process is key. Remember to consult a service manual for your specific vehicle’s torque specs and full procedures.
- Safety First: Always disconnect the negative terminal from your vehicle’s battery and wait at least 10 minutes to allow the system to fully discharge.
- Locate the PCM: On the 1998 GMC Safari and Chevy Astro, the PCM is typically located on the driver’s side of the engine compartment, near the battery.
- Disconnect the Connectors: Carefully unclip and remove the wiring harness connectors from the old PCM. Inspect them for any corrosion or damage. Clean them with an electronics-safe cleaner if necessary.
- Remove the Old Module: Unbolt the PCM from its mounting bracket and remove it from the vehicle.
- Install the New Module: Mount your new, pre-programmed PCM onto the bracket and securely fasten the bolts.
- Reconnect and Secure: Plug the wiring harnesses back into the new module until they click firmly into place. Reconnect the negative battery terminal.
- Perform Security Relearn: Most of these GM vehicles require a simple security relearn procedure to sync the new PCM with your keys. This usually involves turning the key to the ‘ON’ position for 10-15 minutes, then ‘OFF’ for 10 seconds, and repeating this cycle three times. Your vehicle should then start normally.
Will This Fit My Vehicle?
This module is a direct replacement for several GM trucks and vans. Please verify that your vehicle and original part number are listed below. This unit is compatible with service number 16266645 and interchanges with part numbers 09355699, 9355699, 16250279, 16258815, 09366810, and 9366810 when the original module has the ID 9355699.
- GMC Safari: 1998
- Chevrolet Astro: 1998
- Chevrolet & GMC Pickups (1500/2500/3500): 1998-1999 (Gasoline)
- Chevrolet Express & GMC Savana Vans (1500/2500/3500): 1998-1999 (Gasoline)
- Cadillac Escalade: 1999
- Chevrolet Suburban & Tahoe / GMC Yukon: 1998-1999 (Gasoline)
- Oldsmobile Bravada: 1998 (4.3L)
- GMC Envoy: 1998
- Chevrolet S10 / GMC Sonoma: 1998 (4.3L)
- Chevrolet Blazer / GMC Jimmy: 1998 (4.3L)
- Isuzu Hombre: 1998 (4.3L)
Frequently Asked Questions about the 1998 GMC Safari PCM
Do I need to do any programming myself?
Do I need to do any programming myself?
No. We handle all the programming before shipping. We flash the module with the latest GM software using the VIN you provide, so it arrives ready for installation and the security relearn procedure.
Is this a new part?
This is a high-quality, tested used OEM (Original Equipment Manufacturer) part sourced from a salvaged vehicle. This ensures OEM fit and function at a fraction of the cost of a new module from a dealership.
How do I provide my VIN?
After you complete your purchase, you will receive instructions on how to send us your vehicle’s 17-digit VIN. We cannot program and ship your module without it, so please provide it promptly to avoid delays.
What if my original part number is different?
This module is compatible with several part numbers, including 09355699, 16250279, and others listed in the description. As long as your vehicle is on the compatibility list and your original module has the ID 9355699, this part will work for you.