2009-2012 Traverse Body Control Module 95151084 Programmed To Your VIN VIN BCM

Restore Your Traverse’s Electrical System with a Reliable BCM Solution

Are you battling bizarre electrical gremlins in your 2009-2012 Chevrolet Traverse? Intermittent wipers, flickering lights, a dead battery for no reason, or warning messages on the dash can all point to one culprit: a failing Body Control Module (BCM). As the central nervous system for your vehicle’s electronics, when the BCM goes down, it can cause a cascade of frustrating and unpredictable problems. I’ve seen it countless times in my shop—a perfectly good vehicle rendered unreliable by a faulty module.

This isn’t just an inconvenience; it’s a safety and reliability issue. A failing BCM can affect everything from your power locks and windows to your anti-theft system and even communication with other critical modules. Instead of rolling the dice with a costly and time-consuming trip to the dealership, we offer a direct, dependable fix. This listing is for a replacement Body Control Module, part number 95151084, that arrives at your door ready to install thanks to our expert Cloning Service. We transfer the critical data from your original BCM to this replacement unit, ensuring a seamless transition and preserving your vehicle’s specific settings.

Common Symptoms of a Failing GM BCM

If you’re experiencing any of the following, a faulty BCM is the likely cause. Confirming your diagnosis is the first step to a successful repair.

• ✔ Erratic or non-functional interior/exterior lights (headlights, dome lights).
• ✔ Power windows, locks, or mirrors working intermittently or not at all.
• ✔ The security system acting up, or the vehicle not starting due to a false anti-theft trigger.
• ✔ Unexplained battery drain that leaves you stranded.
• ✔ Warning lights on the dashboard, such as for the airbag or traction control system.
• ✔ Communication-related Diagnostic Trouble Codes (DTCs), especially U-codes like U0140 (Lost Communication With BCM).
• ✔ Wipers or radio turning on and off by themselves.

A Straightforward Guide to Your BCM Installation

Replacing your 2009-2012 Traverse BCM is a manageable job for a confident DIYer or any professional technician. Our cloning service eliminates the need for dealership-level programming tools.

1. Safety First: Always disconnect the negative terminal from your vehicle’s battery and wait at least 15 minutes before beginning work. This prevents electrical shorts and allows modules to power down completely.
2. Locate the BCM: On the 2009-2012 Traverse, the BCM is typically located on the left-hand (driver’s) side of the dashboard, often behind the lower dash panel near the steering column.
3. Remove the Old Module: Carefully disconnect the electrical connectors. These connectors have locking tabs that must be depressed to be removed. Once disconnected, unbolt the module from its mounting bracket.
4. Install the New Module: Mount the replacement BCM and securely reconnect all electrical connectors. You should hear a ‘click’ as they lock into place.
5. Reconnect and Test: Reconnect the negative battery terminal. Start the vehicle and test all body functions—lights, locks, windows, radio, etc.—to ensure everything is working correctly.
6. Perform Post-Install Procedures (If Needed): In some cases, you may need to perform a relearn procedure. For example, if the airbag light is on, a scan tool is needed to perform the ‘Setup SDM Primary Key in BCM’ function. A ‘Brake Pedal Position Relearn’ may also be required.

Verified Vehicle Compatibility List

This BCM is a direct replacement for part number 95151084 and interchanges with a wide range of other GM part numbers. It is guaranteed to fit the following vehicles and configurations. Please verify your model and any specific ID numbers mentioned.