Is Your Saturn Vue Shifting Erratically?
If you’re dealing with a 2007, 2008, 2009, or 2010 Saturn Vue that’s slamming into gear, refusing to shift, or has the check engine light glaring at you, the problem is very likely a failed Transmission Control Module (TCM). As a mechanic with over two decades of diagnostic experience, I’ve seen this exact issue hundreds of times. The T42 TCM is the brain of your automatic transmission, and when it fails, it can make your reliable SUV feel unpredictable and unsafe to drive. Don’t assume you need a costly transmission rebuildโoften, the fix is this straightforward, pre-programmed module.
“A customer’s 2008 Vue came in last week with these exact symptoms. It was stuck in 3rd gear (limp mode) and had a P0700 code. They were worried about a multi-thousand dollar repair bill. We confirmed the TCM was the culprit, ordered this VIN-programmed unit, and had them back on the road in under 30 minutes. The relief on their face was pricelessโa simple module replacement saved them a massive headache and expense.”
The Direct Solution for Common Transmission Faults
A failing TCM doesn’t just cause poor performance; it can lead to long-term damage if ignored. This module is a direct-fit replacement for part number 24235732 and other interchangeable numbers, designed to permanently resolve the root cause of your transmission problems. We handle the programming for you, so it arrives ready for a true plug-and-play installation.
- โ Eliminate Harsh Shifting: Puts an end to jarring, delayed, or failed gear changes.
- โ Clear Check Engine Lights: Resolves common diagnostic trouble codes (DTCs) like P0700, P0750-series solenoid codes, and other transmission-related faults.
- โ Escape Limp Mode: Restores full access to all gears, getting your vehicle out of the default safe mode.
- โ Restore Fuel Economy: Ensures efficient torque converter lockup and gear selection for improved MPG.
- โ No Dealership Required: This module is pre-flashed with your vehicle’s specific VIN and the latest GM software, saving you a trip and hundreds in programming fees.
Easy Installation Guide for Your 2007-2010 VUE Transmission Module
You don’t need to be a master mechanic to replace this part. The TCM on the Saturn Vue is located in the engine bay, making it one of the easier electronic components to access. The entire process typically takes less than half an hour.
- Safety First: Disconnect the negative terminal from your vehicle’s battery to prevent electrical shorts and help reset the system.
- Locate the Module: On the 2007-2010 Vue, you’ll find the TCM in the front left (driver’s side) of the engine compartment. It’s a silver box with electrical connectors.
- Disconnect and Remove: Carefully unclip the wiring harnesses. Be gentle with the plastic tabs. Then, unbolt the module from its mounting bracket.
- Install the New Module: Bolt the new, pre-programmed TCM into place. Securely reconnect the wiring harnesses until they click.
- Final Steps: Reconnect the negative battery terminal. Start the vehicle and let it idle for a few minutes. While not always necessary, using a basic OBD2 scan tool to clear any stored codes is a good final step.
Guaranteed Compatibility and Reliability
This module is built to meet or exceed original equipment standards for a long service life. It is compatible with a wide range of GM vehicles using the T42 controller, including many Chevrolet, GMC, Pontiac, and Buick models. We back it with a one-year warranty for your peace of mind. Stop guessing and start driving smoothly again. Order your VIN-programmed TCM today!