2007-2010 Patriot Engine Computer 68043260AA | Plug & Play Programmed

End Your Patriot’s Engine Troubles

Tired of stalling, a no-start condition, or a stubborn check engine light? This Engine Control Module for your 2007-2010 Jeep Patriot, Compass, or Dodge Caliber is the solution. It arrives pre-programmed to your VIN for a simple, plug-and-play installation that requires no dealer visit. Restore your vehicle’s reliability and performance. Order today to get back on the road fast!

$159.95

+11.99 USPS Priority Shipping

Availability: Only 1 left in stock



SKU: 590-01761-47 Categories: ,
Guaranteed Safe Checkout

Restore Peak Performance to Your Jeep or Dodge

Is your Jeep Patriot, Compass, or Dodge Caliber suddenly stalling, refusing to start, or showing a persistent Check Engine Light? These are classic, frustrating symptoms of a failing Engine Control Module (ECM), the computer that acts as your vehicle’s brain. When it starts to fail, it can cause a cascade of problems from poor fuel economy to unpredictable drivability. I’ve seen it countless times in my shop: a customer comes in after replacing sensors and chasing electrical ghosts, only to find the core issue was the ECM itself. This isn’t just an inconvenience; it’s a reliability issue that can leave you stranded.

We offer a dependable and straightforward solution. This Engine Control Module is meticulously prepared to be a direct, plug-and-play replacement. When you order, we flash it with your vehicle’s specific VIN and current mileage. This means no expensive trips to the dealership for programming, no special tools, and no headaches. You’re getting a part that is ready to install right out of the box, designed to restore the precise engine management your vehicle had from the factory. A reliable 2007-2010 Patriot Engine Computer is the key to getting your vehicle back to running smoothly and efficiently.

Case Study: A Tricky Diagnosis

A 2009 Patriot came into the bay with an issue that was driving the owner crazy. It would run perfectly for days, then suddenly die at a stoplight and refuse to restart for an hour. There were no consistent trouble codes, just a random U0100 (Lost Communication with ECM/PCM) that would appear and then clear itself. We checked wiring harnesses and power grounds, but everything looked solid. Based on my experience with these Chrysler platforms, I suspected an internal thermal failure in the ECM. After swapping in one of our pre-programmed modules, the intermittent stalling and communication loss vanished completely. The owner was relieved to finally have a reliable vehicle again after weeks of uncertainty.

Common Signs of a Failing Engine Computer

  • ✔ Check Engine Light is on, often with codes like P0601, P0605, or P0606.
  • ✔ Vehicle will not start or is very difficult to start.
  • ✔ Intermittent stalling or rough idling for no apparent reason.
  • ✔ A noticeable drop in fuel mileage.
  • ✔ Engine performance issues, like hesitation or misfiring.
  • ✔ Automatic transmission shifting problems.
  • ✔ Failure to pass an emissions inspection.

A Straightforward Guide to Installation

Installing your replacement 2007-2010 Patriot Engine Computer is a job most DIYers can handle in their own driveway. Follow these steps for a smooth installation process.

  1. Safety First: Disconnect the negative terminal from your vehicle’s battery and secure it away from the post to prevent any accidental reconnection.
  2. Locate the ECM: On most of these models, the Engine Control Module is located in the engine bay, typically mounted to the firewall or an inner fender.
  3. Disconnect the Harnesses: Carefully release the locking tabs on the electrical connectors and unplug them from the old module. Inspect the connectors for any corrosion or damage.
  4. Remove the Old Module: Unbolt the old ECM from its mounting bracket. There are usually a few 10mm or 8mm bolts holding it in place.
  5. Install the New Module: Mount your new, pre-programmed ECM onto the bracket and secure it with the original bolts.
  6. Reconnect Everything: Plug the electrical harnesses firmly into the new module until they click into place. Reconnect the negative battery terminal.
  7. Final Step: Start the vehicle. It may take a moment to idle smoothly as the computer syncs with the vehicle’s sensors. Your check engine light should be off, and the vehicle is ready to drive!

Verified Vehicle Compatibility

This module is a direct-fit replacement for a wide range of vehicles and part numbers, ensuring you get the correct component. It is guaranteed to fit the following models:

  • ✔ 2007-2010 Jeep Patriot (Electronic Control Module)
  • ✔ 2007-2010 Jeep Compass (Electronic Control Module)
  • ✔ 2007-2008 Dodge Caliber (Electronic Control Module)
  • ✔ 2009 Dodge Caliber (Electronic Control Module; 1.8L, 2.0L Gasoline, 2.4L with engine opt ED3)
  • ✔ 2010 Dodge Caliber (Electronic Control Module; 2.0L, 2.4L)

This unit replaces an extensive list of original part numbers, including: 05150471AA, 05150523AA, 68043260AA, 68043260AB, 68043260AC, 68043260AD, 68043261AA, 68043261AB, 68043261AC, and many more.

Why Choose a Pre-Programmed Module?

The biggest hurdle in replacing a modern engine computer is the software. Our service eliminates that obstacle. By programming the 2007-2010 Patriot Engine Computer to your VIN, we ensure it communicates perfectly with the other modules in your vehicle, like the transmission controller and anti-lock brake system. This saves you from paying dealership diagnostic and programming fees, which can often exceed the cost of the part itself. Get the confidence of a professional repair at a fraction of the cost and hassle.

Do I need to do any programming myself?

Do I need to do any programming myself?

No. This engine computer arrives fully programmed to your vehicle’s VIN and mileage. It is a true plug-and-play solution, requiring no additional programming or dealer intervention.

Where do I find my VIN?

Your 17-digit Vehicle Identification Number (VIN) can be found on your vehicle’s registration, insurance card, or on the driver’s side of the dashboard, visible through the windshield.

Is this compatible with my existing keys?

Yes. Because we program the module to your specific VIN, it will correctly recognize your vehicle’s factory-installed anti-theft system and existing keys. No key reprogramming is necessary.

Will this fix my specific problem?

This module is designed to fix issues directly caused by a faulty ECM. While it resolves the most common symptoms like no-start, stalling, and internal processor codes (P0601, etc.), we always recommend a proper diagnosis to confirm the ECM is the point of failure before ordering.

Condition

Refurbished

Genuine OEM

Yes

MPN

68043260aa

Interchange part number

PartNumber

590

Model

PATRIOT

Year

2007

Brand

Chrysler

Manufacturer Part Number

, , , , , , , , , , , , , , , , , , , , , , ,

Scroll to Top