Is Your Jeep Compass Stalling, Running Rough, or Showing a Check Engine Light?
If you’re dealing with frustrating engine problems in your 2007-2010 Jeep Compass, a faulty Engine Control Module (ECM) is a very likely culprit. Over my 20+ years in the shop, I’ve seen these exact symptoms hundreds of times. A failing ECM can cause a cascade of issues that seem unrelated, from poor fuel economy and hesitation to a complete no-start condition, leaving you stranded. Don’t keep guessing or replacing perfectly good sensors. This is the direct, reliable solution you need.
A Technician’s Real-World Experience
“A customer’s 2009 Compass came in last month with an intermittent stalling problem that no other shop could solve. They had replaced the crank sensor and fuel pump, but the issue persisted. After hooking up my diagnostic scanner, I noticed erratic data readings and communication dropouts from the ECM. We installed one of our pre-programmed modules, and the vehicle has been running perfectly ever since. The problem wasn’t the parts they replaced; it was the computer controlling them.”
The Simple Solution: A Pre-Programmed 2007-2010 Compass Engine Computer
Forget expensive dealership visits and complex programming tools. We take all the guesswork out of the repair. This Engine Control Module arrives at your door completely programmed to your vehicle’s specific VIN and mileage. It’s a true plug-and-play component, designed to get you back on the road with minimal downtime and frustration.
- โ No Programming Required: This module is delivered fully flashed and ready for installation right out of the box.
- โ Guaranteed VIN Match: We program the unit with your vehicle’s information, ensuring seamless communication with all other onboard systems.
- โ Solves Common Issues: Effectively resolves problems like check engine lights (CEL), rough idle, stalling, hesitation, and no-start conditions related to a faulty ECM.
- โ Cost-Effective Repair: Save hundreds of dollars compared to the cost of a new module and programming fees at a dealership.
Plug-and-Play Installation: No Dealer Visit Required
You can perform this replacement yourself with basic hand tools. Follow these simple steps to restore your vehicle’s performance.
- Safety First: Disconnect the negative terminal from your vehicle’s battery to prevent any electrical shorts.
- Locate the ECM: On the 2007-2010 Compass, the ECM is typically located in the engine bay, often near the battery or firewall.
- Disconnect Connectors: Carefully unclip the wiring harness connectors from the old module. Inspect them for any signs of corrosion or damage.
- Remove the Old Module: Unbolt the mounting hardware holding the original ECM in place and remove it from the vehicle.
- Install the New Module: Mount your new, pre-programmed ECM in the same location and secure it with the original hardware.
- Reconnect Everything: Firmly plug the wiring harness connectors into the new module until they click. Reconnect the negative battery terminal.
- Final Check: Start the engine. The check engine light should be off, and the vehicle should run smoothly. Your repair is complete!
Expert Pro Tip: Clean Your Connections
Before plugging in your new ECM, take a moment to spray the vehicle’s harness connectors with a quality electronics cleaner. Use a small, soft brush (like a toothbrush) to gently scrub away any dirt or light corrosion. A clean, solid connection is critical for the new module to function correctly and can prevent a host of future electrical gremlins.
Guaranteed Compatibility
This module is a direct replacement for a wide range of vehicles and part numbers, ensuring you get the correct component for your specific application. It is compatible with the following part numbers and models:
Part Numbers: 05150471AA, 05150523AA, 68043260AA, 68043260AB, 04692101AD, 04692101AE, 04692101AF, 68043260AC, 68043260AD, 68043261AC, 68043261AA, 68043261AB, 68070011AA, 68071022AA, 05033359AJ, 05187817AF, 68000107AF, 68026147AA, 68026147AC, 68028201AA, 68028201AC, 68028205AB, 68044228AA
Vehicle Fitment:
- 2007-2010 Jeep Compass (All Engines)
- 2007-2010 Jeep Patriot (All Engines)
- 2007-2008 Dodge Caliber (All Engines)
- 2009 Dodge Caliber (1.8L, 2.0L Gasoline, 2.4L with engine opt ED3)
- 2010 Dodge Caliber (2.0L, 2.4L)