Programmed 2007-2009 SRX Body Control Module 15921353 | Cloning Service

Restore Your Cadillac’s Electrical System with a Reliable BCM Solution

Is your 2007-2009 Cadillac SRX experiencing a host of frustrating electrical issues? One minute the power windows work, the next they don’t. Maybe the interior lights are flickering, the security system is acting up, or you’re facing an intermittent no-start condition that leaves you stranded. As a technician with over two decades of experience, I’ve seen these exact symptoms countless times, and they almost always point to a failing Body Control Module (BCM). The BCM is the central command center for your vehicle’s body electronics, and when it fails, it can cause widespread, confusing problems.

This isn’t just a replacement part; it’s a complete, ready-to-install solution. We offer a professional Cloning Service with this BCM. This means we transfer the exact data from your original, faulty module directly onto this replacement unit. The result? A true plug-and-play installation that bypasses the need for an expensive trip to the dealership for programming. Simply provide us with your vehicle’s VIN after purchase, and we’ll handle the rest, ensuring your 2007-2009 SRX Body Control Module arrives ready to restore full functionality to your vehicle.

Common Signs of a Failing BCM

If your vehicle is exhibiting any of these symptoms, a faulty BCM could be the culprit. A failing 2007-2009 SRX Body Control Module can disrupt nearly every comfort and convenience feature in your Cadillac.

• ✔ Erratic or non-functional power windows, door locks, and mirrors.
• ✔ Interior or exterior lights that flicker, stay on, or don’t work at all.
• ✔ The security system light is on, or the alarm goes off randomly.
• ✔ Intermittent no-start or no-crank conditions.
• ✔ Warning lights on the dashboard, such as for the airbag or brake system.
• ✔ Communication error codes (U-codes) stored in the vehicle’s computer system.
• ✔ Wipers or radio functioning incorrectly or not at all.

A Straightforward Guide to Installation

Thanks to our cloning service, installing your new BCM is a direct swap. For the 2007-2009 SRX, the BCM is located on the left-hand side of the dashboard. While specific steps can vary, here is a general guide to the process.

1. Safety First: Disconnect the negative terminal from your vehicle’s battery and wait a few minutes to ensure all systems are powered down.
2. Locate the BCM: On your SRX, you will typically need to remove the lower dash panel on the driver’s side to access the module.
3. Disconnect and Remove: Carefully unplug the electrical connectors from the old BCM. They have locking tabs that need to be depressed. Once disconnected, unbolt or unclip the module from its mounting bracket.
4. Install the New Module: Mount your new, pre-programmed BCM in the same location and securely reconnect all electrical connectors. You should hear a ‘click’ as they lock into place.
5. Reconnect and Test: Reconnect the negative battery terminal. Turn the key to the ‘On’ position and test all functions: lights, windows, locks, wipers, and radio. Start the vehicle to ensure it runs correctly.

Important Post-Installation Information

In some cases, additional steps may be required after installation to ensure all vehicle systems communicate correctly. Please be aware of the following potential procedures:

• Airbag System Sync: If the airbag warning light is illuminated after installation, a ‘Setup SDM Primary Key in BCM’ procedure must be performed with a professional scan tool to sync the systems.
• Brake Pedal Position Relearn: Some models may require a brake pedal position sensor recalibration to ensure correct brake light and traction control operation.

Disclaimer: Always consult a factory service manual or a qualified technician for procedures specific to your vehicle.

Verified Vehicle Compatibility

This Body Control Module is a direct fit for the 2007-2009 Cadillac SRX. It is also compatible with a wide range of other General Motors vehicles. Please verify your original part number against the list below to ensure proper fitment. This module replaces the following part numbers:

10382479, 15093910, 15276271, 15299986, 15819552, 15828601, 15837419, 15872388, 15872421, 15880684, 15921352, 15921353, 15948438, 15948439, 20815898, 20839063, 20864767, 20864768, 20921435, 20921436, 20935349, 22860591, 25826124, 25826125, 25847588, 25847589, 25892622, 25910474, 25934762, 25934763, 95151084